rt-thread/bsp/ck802/libraries/include/drv_eth.h

106 lines
3.7 KiB
C

/**
* Copyright (C) 2016 CSI Project. All rights reserved.
*
* Licensed under the Apache License, Version 2.0 (the "License");
* you may not use this file except in compliance with the License.
* You may obtain a copy of the License at
*
* http://www.apache.org/licenses/LICENSE-2.0
*
* Unless required by applicable law or agreed to in writing, software
* distributed under the License is distributed on an "AS IS" BASIS,
* WITHOUT WARRANTIES OR CONDITIONS OF ANY KIND, either express or implied.
* See the License for the specific language governing permissions and
* limitations under the License.
*/
#ifndef _CSI_NET_H_
#define _CSI_NET_H_
#ifdef __cplusplus
extern "C" {
#endif
#define CSI_ETH_VERSION_MAJOR_MINOR(major,minor) (((major) << 8) | (minor))
/**
\brief Driver Version
*/
typedef struct csi_driver_version {
uint16_t api; ///< API version
uint16_t drv; ///< Driver version
} csi_drv_version_t;
/* General return codes */
#define CSI_ETH_OK 0 ///< Operation succeeded
#define CSI_ETH_ERROR CSI_DRV_ERRNO_ETH_BASE+1 ///< Unspecified error
#define CSI_ETH_ERROR_BUSY CSI_DRV_ERRNO_ETH_BASE+2 ///< Driver is busy
#define CSI_ETH_ERROR_TIMEOUT CSI_DRV_ERRNO_ETH_BASE+3 ///< Timeout occurred
#define CSI_ETH_ERROR_UNSUPPORTED CSI_DRV_ERRNO_ETH_BASE+4 ///< Operation not supported
#define CSI_ETH_ERROR_PARAMETER CSI_DRV_ERRNO_ETH_BASE+5 ///< Parameter error
#define CSI_ETH_ERROR_SPECIFIC CSI_DRV_ERRNO_ETH_BASE+6 ///< Start of driver specific errors
/**
\brief General power states
*/
typedef enum eth_power_state {
CSI_ETH_POWER_OFF, ///< Power off: no operation possible
CSI_ETH_POWER_LOW, ///< Low Power mode: retain state, detect and signal wake-up events
CSI_ETH_POWER_FULL ///< Power on: full operation at maximum performance
} eth_power_state_t;
/**
\brief Ethernet Media Interface type
*/
#define CSI_ETH_INTERFACE_MII (0) ///< Media Independent Interface (MII)
#define CSI_ETH_INTERFACE_RMII (1) ///< Reduced Media Independent Interface (RMII)
#define CSI_ETH_INTERFACE_SMII (2) ///< Serial Media Independent Interface (SMII)
/**
\brief Ethernet link speed
*/
#define CSI_ETH_SPEED_10M (0) ///< 10 Mbps link speed
#define CSI_ETH_SPEED_100M (1) ///< 100 Mbps link speed
#define CSI_ETH_SPEED_1G (2) ///< 1 Gpbs link speed
/**
\brief Ethernet duplex mode
*/
#define CSI_ETH_DUPLEX_HALF (0) ///< Half duplex link
#define CSI_ETH_DUPLEX_FULL (1) ///< Full duplex link
/**
\brief Ethernet link state
*/
typedef enum eth_link_state {
ETH_LINK_DOWN, ///< Link is down
ETH_LINK_UP ///< Link is up
} eth_link_state_t;
/**
\brief Ethernet link information
*/
typedef volatile struct eth_link_info {
uint32_t speed : 2; ///< Link speed: 0= 10 MBit, 1= 100 MBit, 2= 1 GBit
uint32_t duplex : 1; ///< Duplex mode: 0= Half, 1= Full
uint32_t Autonegotiation : 1; ///< Set the interface to Auto Negotiation mode of transmission parameters
uint32_t Loopback : 1; ///< Set the interface into a Loop-back test mode
uint32_t Isolation : 1; ///< Set to indicate electrical isolation of PHY interface from MII/RMII interface
uint32_t reserved : 26;
} eth_link_info_t;
/**
\brief Ethernet MAC Address
*/
typedef struct eth_mac_addr {
uint8_t b[6]; ///< MAC Address (6 bytes), MSB first
} eth_mac_addr_t;
#ifdef __cplusplus
}
#endif
#endif /* CSI_NET_H_ */