rt-thread/bsp/stm32/stm32f411-st-nucleo/board/Kconfig

99 lines
2.4 KiB
Plaintext

menu "Hardware Drivers Config"
config SOC_STM32F411RE
bool
select SOC_SERIES_STM32F4
default y
menu "Onboard Peripheral Drivers"
endmenu
menu "On-chip Peripheral Drivers"
config BSP_USING_GPIO
bool "Enable GPIO"
select RT_USING_PIN
default y
menuconfig BSP_USING_UART
bool "Enable UART"
default y
select RT_USING_SERIAL
if BSP_USING_UART
config BSP_USING_UART2
bool "Enable UART2"
default y
config BSP_UART2_RX_USING_DMA
bool "Enable UART2 RX DMA"
depends on BSP_USING_UART2 && RT_SERIAL_USING_DMA
default n
config BSP_USING_UART6
bool "Enable UART6"
default y
config BSP_UART6_RX_USING_DMA
bool "Enable UART6 RX DMA"
depends on BSP_USING_UART6 && RT_SERIAL_USING_DMA
default n
endif
menuconfig BSP_USING_I2C1
bool "Enable I2C1 BUS (software simulation)"
default n
select RT_USING_I2C
select RT_USING_I2C_BITOPS
select RT_USING_PIN
if BSP_USING_I2C1
comment "Notice: PB8 --> 24; PB9 --> 25"
config BSP_I2C1_SCL_PIN
int "i2c1 scl pin number"
range 0 80
default 24
config BSP_I2C1_SDA_PIN
int "I2C1 sda pin number"
range 0 80
default 25
endif
menuconfig BSP_USING_PWM
bool "Enable pwm"
default n
select RT_USING_PWM
if BSP_USING_PWM
menuconfig BSP_USING_PWM3
bool "Enable timer3 output pwm"
default n
if BSP_USING_PWM3
config BSP_USING_PWM3_CH1
bool "Enable PWM3 channel1 (PA6)"
default n
config BSP_USING_PWM3_CH2
bool "Enable PWM3 channel2 (PA7)"
default n
config BSP_USING_PWM3_CH3
bool "Enable PWM3 channel3 (PB0)"
default n
config BSP_USING_PWM3_CH4
bool "Enable PWM3 channel4 (PB1)"
default n
endif
endif
config BSP_USING_ON_CHIP_FLASH
bool "Enable on-chip FLASH"
default n
endmenu
menu "Board extended module Drivers"
endmenu
endmenu