menu "Hardware Drivers Config"

    menu "On-chip Peripheral Drivers"
        config BSP_USING_GPIO
            bool "Enable GPIO"
            select RT_USING_PIN
            default y

        menu "UART Drivers"
            config BSP_USING_UART0
                bool "Enable UART0 PB10/PB11(T/R)"
                select RT_USING_SERIAL
                default n

            config BSP_USING_UART1
                bool "Enable UART1 PC10/PC11(T/R)"
                select RT_USING_SERIAL
                default n

            config BSP_USING_UART2
                bool "Enable UART2 PC12/PD02(T/R)"
                select RT_USING_SERIAL
                default y
                depends on !BSP_USING_HWTIMER1

            config BSP_USING_UART3
                bool "Enable UART3 PC04/PC05(T/R)"
                select RT_USING_SERIAL
                default n
                depends on !BSP_USING_HWTIMER2

            
            config BSP_USING_UART4
                bool "Enable UART4 PB06/PB07(T/R)"
                select RT_USING_SERIAL
                default n
                depends on !BSP_USING_I2C0

            config BSP_USING_UART5
                bool "Enable UART5 PB09/PB08(T/R)"
                select RT_USING_SERIAL
                default n
        endmenu

        menu "SPI Drivers"
            config BSP_USING_SPI0
                bool "Enable SPI0 BUS PB03/PB04/PB05(CLK/MISO/MOSI)"
                select RT_USING_SPI
                select RT_USING_PIN
                default n

            config BSP_USING_SPI1
                bool "Enable SPI1 BUS PC01/PC02/PC03(CLK/MISO/MOSI)"
                select RT_USING_SPI
                select RT_USING_PIN
                default n

            config BSP_USING_SPI2
                bool "Enable SPI2 BUS PC05/PB00/PB01(CLK/MISO/MOSI)"
                select RT_USING_SPI
                select RT_USING_PIN
                default n
        endmenu

        menu "I2C Drivers"
            config BSP_USING_I2C0
                bool "Enable I2C0 BUS PB08/PB09(SCL/SDA)"
                select RT_USING_I2C
                default n

            config BSP_USING_I2C1
                bool "Enable I2C1 BUS PB10/PB11(SCL/SDA)"
                select RT_USING_I2C
                default n
        endmenu

        menu "CAN Drivers"
            config BSP_USING_CAN
                bool "Enable CAN BUS PB08/PB09(RX/TX)"
                select RT_USING_CAN
                default n
        endmenu
    endmenu

    menu "Onboard Peripheral Drivers"

    endmenu

    menu "Offboard Peripheral Drivers"

    endmenu

endmenu