menu "Hardware Drivers Config"

config SOC_STM32F769NI
    bool
    select SOC_SERIES_STM32F7
    select RT_USING_COMPONENTS_INIT
    select RT_USING_USER_MAIN
    default y

menu "Onboard Peripheral Drivers"

    config BSP_USING_ETH
        bool "Enable Ethernet"
        select RT_USING_LWIP
        default n

        if BSP_USING_ETH
            choice
                prompt "On-board PHY chip"
                default PHY_USING_DP83848C

                config PHY_USING_DP83848C
                    bool "DP83848C"

                config PHY_USING_LAN8720A
                    bool "LAN8720A"

                config PHY_USING_DM9161CEP
                    bool "DM9161CEP"

            endchoice
        endif

endmenu

menu "On-chip Peripheral Drivers"

    config BSP_USING_GPIO
        bool "Enable GPIO"
        select RT_USING_PIN
        default y

    menuconfig BSP_USING_UART
        bool "Enable UART"
        default y
        select RT_USING_SERIAL
        if BSP_USING_UART
            config BSP_USING_UART1
                bool "Enable UART1"
                default y

            config BSP_UART1_RX_USING_DMA
                bool "Enable UART1 RX DMA"
                depends on BSP_USING_UART1 && RT_SERIAL_USING_DMA
                default n

            config BSP_UART1_TX_USING_DMA
                bool "Enable UART1 TX DMA"
                depends on BSP_USING_UART1 && RT_SERIAL_USING_DMA
                default n

            config BSP_USING_UART5
                bool "Enable UART5"
                default n

            config BSP_UART5_RX_USING_DMA
                bool "Enable UART5 RX DMA"
                depends on BSP_USING_UART5 && RT_SERIAL_USING_DMA
                default n

            config BSP_UART5_TX_USING_DMA
                bool "Enable UART5 TX DMA"
                depends on BSP_USING_UART5 && RT_SERIAL_USING_DMA
                default n
        endif

    source "$BSP_DIR/../libraries/HAL_Drivers/drivers/Kconfig"

endmenu

menu "Board extended module Drivers"

endmenu

endmenu