menu "Hardware Drivers"

menu "On-chip Peripheral Drivers"
    menuconfig BSP_USING_UART
        bool "Enable UART"
        default y
        select USE_SERIAL # sdk serial component
        select RT_USING_SERIAL
        if BSP_USING_UART
            config RT_USING_UART1
                bool "Enable UART1"
                default y
            
            config RT_USING_UART0
                bool "Enable UART0"
                default n

        endif

    menuconfig BSP_USING_SPI
        bool "Enable Spi"
        default n
        select USE_SPI # sdk spi component
        select RT_USING_SPI
        if BSP_USING_SPI
            config RT_USING_SPIM0
                bool "Enable spim0"
                default n

            config RT_USING_SPIM1
                bool "Enable spim1"
                default n
            
            config RT_USING_SPIM2
                bool "Enable spim2"
                default y

            config RT_USING_SPIM3
                bool "Enable spim3"
                default n
        endif

    menuconfig BSP_USING_CAN
        bool "Enable CAN"
        default n
        select RT_USING_CAN
        select RT_CAN_USING_HDR
        select RT_CAN_USING_CANFD

    menuconfig BSP_USING_GPIO
        bool "Enable GPIO"
        default n
        select RT_USING_PIN

    menuconfig BSP_USING_QSPI
        bool "Enable QSPI"
        default n
        select RT_USING_QSPI
        select RT_USING_SPI
        select BSP_USING_SPI
        select BSP_USING_GPIO
        if BSP_USING_QSPI
            config USING_QSPI_CHANNEL0
                bool "using qspi channel_0"
                default n
            config USING_QSPI_CHANNEL1
                bool "using qspi channel_1"
                default n
        endif

    menuconfig BSP_USING_ETH
        bool "Enable ETH"
        default y
        select USE_ETH 
        if BSP_USING_ETH
            config RT_LWIP_PBUF_POOL_BUFSIZE
                        int "The size of each pbuf in the pbuf pool"
                        range 1500 2000
                        default 1700
        endif
       

           
    
    menuconfig BSP_USING_SDIO
        bool "Enable SDIO"
        default y
        select RT_USING_SDIO
    
        if BSP_USING_SDIO
                config BSP_USING_SDCARD_FATFS
                    bool "Enable SDCARD (FATFS)"
                    select RT_USING_DFS_ELMFAT
                    default y
    
                choice
                    prompt "Choose a card to mount"
                    default USING_SDIO1

                    config USING_SDIO0
                        bool "Use SDIO0"

                    config USING_SDIO1
                        bool "Use SDIO1"

                    config USING_EMMC
                        bool "Use EMMC"
                endchoice  
        endif
endmenu

menu "Board extended module Drivers"

endmenu

endmenu