When compiling C code containing statements like this:
rt_base_t xx_io_tbl[] =
{
GET_PIN(A,0),
};
the compiler will report:
Warning: #1296-D: extended constant initialiser used
1. Add "drv_eth.c" for all imxrt platforms.
2. Add ksz8081 phy driver for imxrt1052-nxp-evk board.
3. Disable the LED demo in main.c file if enable the ENET
and ksz8081 phy, because the PINs of LED and ksz8081
reset are from the same GPIO.
4. Update the relevant Kconfig and Sconscript files.
Signed-off-by: Gavin Liu <gavin-liugang@outlook.com>
1. Add sdram item in bsp/imxrt/imxrt1052-nxp-evk/board/Kconfig
2. Add sdram configuration header file for imxrt1052-nxp-evk
3. Update the sdram space assignment for memheap
Signed-off-by: Gavin Liu <gavin-liugang@outlook.com>
Add PINs init function based on the selected UART port.
In general, user should configure all necessary PINs based on
the specific imxrt board in:
bsp/imxrt/xxxx/board/MCUX_Config/pin_mux.c
There is a convenient GUI tool named MCUXpresso Config Tools,
it's free and can be obtained from NXP offical website. Open
the file:
bsp/imxrt/imxrt1052-nxp-evk/board/MCUX_Config/MCUX_Config.mex
with MCUXpresso Config Tools, set the necessary PINs (or clocks)
and generate the new code of pin_mux.c (or clock_config.c), the
project can get right configurations based on specific imxrt
board.
But, there is no relation between RT-Thread Kconfig and MCUXpresso
Config Tools. User selects one driver in RT-Thread menuconfig, then
the ping_mux.c should be udpated by MCUXpresso Config Tools to set
the right PIN configurations for the selected driver. It's clear
but a little complex.
We add the PIN init functions for some drivers in the board.c file,
1. It's convenient to usr a driver in RT-Thread. Just select the
driver, then the code will include all necessary parts, and the
driver can work well.
2. User can also configure the PINs with MCUXpresso Config Tools.
3. The drivers in bsp/imxrt/libraries/drivers are common for all
imxrt boards. They may have different PIN configurations based
on different hardware design. So we put the PIN init functions
in each board.c file following each different imxrt board.
Signed-off-by: Gavin Liu <gavin-liugang@outlook.com>
armink
ZYH
Ernest
Bernard Xiong
aozima
tyustli
guozhanxin
xuzhuoyi
tangweikang
whj4674672
yygg_you
chenyong
SummerGift
a1012112796
gbcwbz
Gavin Liu