menu "Hardware Drivers Config"

    config SOC_STM32H743II
        bool
        select SOC_SERIES_STM32H7
        select RT_USING_COMPONENTS_INIT
        select RT_USING_USER_MAIN
        default y
    
    menu "On-chip Peripheral Drivers"

        config BSP_USING_GPIO
            bool "Enable GPIO"
            select RT_USING_PIN
            default y

        menuconfig BSP_USING_UART
            bool "Enable UART"
            default y
            select RT_USING_SERIAL

            if BSP_USING_UART
                config BSP_USING_UART1
                    bool "Enable UART1"
                    default y

                config BSP_UART1_RX_USING_DMA
                    bool "Enable UART1 RX DMA"
                    depends on BSP_USING_UART1 && RT_SERIAL_USING_DMA
                    default n

                config BSP_USING_UART2
                    bool "Enable UART2"
                    default n

                config BSP_UART2_RX_USING_DMA
                    bool "Enable UART2 RX DMA"
                    depends on BSP_USING_UART2 && RT_SERIAL_USING_DMA
                    default n
                    
                config BSP_USING_LPUART1
                    bool "Enable LPUART1"
                    default n

                config BSP_LPUART1_RX_USING_DMA
                    bool "Enable LPUART1 RX DMA"
                    depends on BSP_USING_LPUART1 && RT_SERIAL_USING_DMA
                    default n
            endif
            
            config BSP_USING_QSPI
                bool "Enable QSPI BUS"
                select RT_USING_QSPI
                select RT_USING_SPI
                default n

        source "../libraries/HAL_Drivers/Kconfig"
            
    endmenu

    menu "Onboard Peripheral Drivers"

        config BSP_USING_SDRAM
            bool "Enable SDRAM"
            default n

        config BSP_USING_QSPI_FLASH
            bool "Enable QSPI FLASH (W25Q256 qspi)"
            select BSP_USING_QSPI
            select RT_USING_SFUD
            select RT_SFUD_USING_QSPI
            default n

        config BSP_USING_SDMMC
            bool "Enable SDMMC (SD card)"
            select RT_USING_SDIO
            select RT_USING_DFS
            select RT_USING_DFS_ELMFAT
            default n

    endmenu

endmenu