menu "Hardware Drivers Config" menu "On-chip Peripheral Drivers" source "$(BSP_DIR)/../libraries/nuc980/rtt_port/Kconfig" endmenu menu "On-board Peripheral Drivers" config BSP_USING_CONSOLE bool "Enable UART0 for RTT Console(uart0)" select BSP_USING_UART select BSP_USING_UART0 default y config BOARD_USING_UART8_RS485 bool "Enable UART8 for RS485(AUD) communication(uart8)" select BSP_USING_UART select BSP_USING_UART8 default y config BOARD_USING_STORAGE_SPIFLASH bool "SPI NOR FLASH supporting(over qspi0)" select BSP_USING_QSPI select BSP_USING_QSPI0 default y config BOARD_USING_USB0_DEVICE_HOST select BSP_USING_USBH select BSP_USING_USBD bool "Enable USB0 Device/Host" help Choose this option if you need USB device or host function mode. If you need USB host, please remember short to ground on JP1 jumper. endmenu menu "Board extended module drivers" config BOARD_USING_IP101GR bool "Enable ethernet phy supporting(over emac/mdio)" select BSP_USING_EMAC select BSP_USING_EMAC1 default n endmenu source "$(BSP_DIR)/../libraries/nu_packages/Kconfig" endmenu