menu "Hardware Drivers Config"

menu "Onboard Peripheral Drivers"

    config BSP_USING_STLINK_TO_USART
        bool "Enable STLINK TO USART (uart3)"
        select BSP_USING_UART
        select BSP_USING_UART3
        default y

    config BSP_USING_DSI
        bool "Enable LCD"
        select BSP_USING_SRAM
        select BSP_USING_GFXMMU
        default n

    menu "Enable Touch"

        config BSP_USING_TOUCH
            bool "Enable Touch drivers"
            select BSP_USING_I2C1
            default n
            if BSP_USING_TOUCH
                config BSP_TOUCH_INT_PIN
                    int "Touch interrupt pin"
                    default 34
                    config BSP_I2C1_NAME
                    string "I2C1 Name for Touch"
                    default i2c1
            endif

        config TOUCH_IC_FT3X67
        bool "FT3X67"
        depends on BSP_USING_TOUCH
        default n

    endmenu
endmenu

menu "On-chip Peripheral Drivers"

    config BSP_USING_GPIO
        bool "Enable GPIO"
        select RT_USING_PIN
        default y

    menuconfig BSP_USING_UART
        bool "Enable UART"
        default y
        select RT_USING_SERIAL
        if BSP_USING_UART
            config BSP_USING_UART3
            bool "Enable UART3"
            default y
        endif

    config BSP_USING_SRAM
        bool "Enable SRAM"
        select BSP_USING_FMC
        default n

    menuconfig BSP_USING_I2C1
    bool "Enable I2C1 BUS (software simulation)"
        default n
        select RT_USING_I2C
        select RT_USING_I2C_BITOPS
        select RT_USING_PIN
        if BSP_USING_I2C1
            config BSP_I2C1_SCL_PIN
            int "i2c1 scl pin number"
            range 1 216
            default 116
            config BSP_I2C1_SDA_PIN
            int "I2C1 sda pin number"
            range 1 216
            default 117
        endif

    config BSP_USING_GFXMMU
        bool
        default n

    config BSP_USING_FMC
        bool
        default n
    source "$(BSP_DIR)/../libraries/HAL_Drivers/drivers/Kconfig"

endmenu

menu "Board extended module Drivers"

endmenu

endmenu