rt-thread-official/components/drivers/spi/Kconfig

68 lines
2.0 KiB
Plaintext
Raw Permalink Normal View History

config RT_USING_SPI
bool "Using SPI Bus/Device device drivers"
default n
if RT_USING_SPI
config RT_USING_SPI_BITOPS
select RT_USING_PIN
bool "Use GPIO to simulate SPI"
default n
if RT_USING_SPI_BITOPS
config RT_SPI_BITOPS_DEBUG
bool "Use simulate SPI debug message"
default n
endif
config RT_USING_QSPI
bool "Enable QSPI mode"
default n
config RT_USING_SPI_MSD
bool "Using SD/TF card driver with spi"
select RT_USING_DFS
default n
config RT_USING_SFUD
bool "Using Serial Flash Universal Driver"
default n
help
An using JEDEC's SFDP standard serial (SPI) flash universal driver library
if RT_USING_SFUD
config RT_SFUD_USING_SFDP
bool "Using auto probe flash JEDEC SFDP parameter"
default y
config RT_SFUD_USING_FLASH_INFO_TABLE
bool "Using defined supported flash chip information table"
default y
config RT_SFUD_USING_QSPI
bool "Using QSPI mode support"
select RT_USING_QSPI
default n
config RT_SFUD_SPI_MAX_HZ
int "Default spi maximum speed(HZ)"
range 0 50000000
default 50000000
help
Read the JEDEC SFDP command must run at 50 MHz or less,and you also can use rt_spi_configure(); to config spi speed.
config RT_DEBUG_SFUD
bool "Show more SFUD debug information"
default n
endif
config RT_USING_ENC28J60
bool "Using ENC28J60 SPI Ethernet network interface"
select RT_USING_LWIP
default n
config RT_USING_SPI_WIFI
bool "Using RW009/007 SPI Wi-Fi wireless interface"
select RT_USING_LWIP
default n
endif