newlib-cygwin/libgloss/m68k/idp-outbyte.c

73 lines
2.5 KiB
C
Raw Normal View History

2000-03-18 06:48:54 +08:00
/* idp-outbyte.c
* Copyright (c) 1995 Cygnus Support
*
* The authors hereby grant permission to use, copy, modify, distribute,
* and license this software and its documentation for any purpose, provided
* that existing copyright notices are retained in all copies and that this
* notice is included verbatim in any distributions. No written agreement,
* license, or royalty fee is required for any of the authorized uses.
* Modifications to this software may be copyrighted by their authors
* and need not follow the licensing terms described here, provided that
* the new terms are clearly indicated on the first page of each file where
* they apply.
*/
#include <_ansi.h>
#include "mc68681reg.h"
/*
* The DUART is mapped into the IDP address space in an unusual
* manner. The mc68681 is an 8 bit device located on the least
* significant byte (byte0) of the data bus. Bytes 3, 2, and
* one have nothing in them and writes to these locations are
* not valid.
*/
#define DUART_ADDR 0x00B00000
#define READREG(x) (*((volatile char *) DUART_ADDR + (x * 4) + 3))
#define WRITEREG(x, y) (*((char *) DUART_ADDR + (x * 4) + 3) = y)
/*
* raw_outbyte -- send a byte to the DUART buffer. This only sends
2000-03-18 06:48:54 +08:00
* to channel A.
*/
static void
raw_outbyte (char byte)
2000-03-18 06:48:54 +08:00
{
/* First, wait for the UART to finish clocking out the last
character we sent, if any. Then, give it the next character to
work on. By waiting first, then handing off a new character, we
allow the UART to work while the processor (perhaps) does other
things; if we waited after sending each character, there'd be no
opportunity for parallelism. */
2000-03-18 06:48:54 +08:00
while ((READREG (DUART_SRA) & 0x04) == 0x00)
;
WRITEREG (DUART_TBA, byte); /* write the byte */
}
/*
* outbyte -- send BYTE out the DUART's channel A, for display to
* the user.
*
* Normally, this is identical to raw_outbyte, but if
* GDB_MONITOR_OUTPUT is #defined, we prefix each byte we send
* with a ^O character (ASCII 15). This is a signal to GDB's
* `rom68k' target to pass the character directly on to the user;
* it allows programs to do console output under GDB.
*
* We compile this file twice: once with GDB_MONITOR_OUTPUT
* #defined, and once without. The former .o file we put in
* libidpgdb.a, which is included in the link by idpgdb.ld; the
* latter we put in libidp.a, which is selected by idp.ld.
*/
void
outbyte (char byte)
{
#ifdef GDB_MONITOR_OUTPUT
raw_outbyte (0x0f);
#endif
raw_outbyte (byte);
}